Polyurethane Motor Mounts

[DSMoverJDM]

so i took my car for a paint job and also asked if they can swap my motor mounts for me. i had bought these polyurethane motor mounts online that fit the 97 eclipse rs but they said they cant install it because they need a special tool or w/e to install these inserts. what tools would you need and how much would a average mechanic charge me to do this job

 

[blizz99]

They probably need to cut/press the old motor mount inserts.

 

[Idaho AWD]

If anything they might need to be pressed in but when I installed them in my 1g I was able to use a board and mallet. I personally didnt like them as you could feel every little vibration from the engine.

 

[DSMoverJDM]

well i think any motor mount swap would be better than the ones i have now. my steering wheel shakes pretty bad and shakes when i switch from drive to reverse so i want to get them swapped whenever i can.

 

[Dsmamature92]

what would be a good choice of mounts? and any good websites for parts?

 

[Rsawd95dsm]

Its either stock, polys, or solid aluminum ones. And try Welcome To Extreme PSI And yes they cant do them because its a hassel to get the old mounts out of the cases but it takes a rubber mallet to put polys back into the cases

 

[3kgt2nv]

look under the supporting vendor section for some of the companies that support the platform.

 

[DSMReviver]

You can just modified your existing motor mounts and make them stronger. Here is how you do it and its cheap and simple.

How to Make Fill Your Engine Mounts With Window Weld - Solid Mounts

 

[Dsmamature92]

dose these sites sell stock or aftermarket parts?

 

[Smeed78]

I have Prothane mounts on my GST and they needed to be pressed. My uncle did this for me since he had the right equipment to get the job done. They are noticeably different from the stock mounts.