Manual tranny Screaching after clutch install

[Totaleclipse04]

ok heres the story i have a 97 GST with slight mods. Im running a ACT 2600 clutch and pressure plate. I have about 15k on it. Then... One sunday morning i sa drivig it to work started and drove fine to the quick trip i went inside got my drink went back outside. I got in my car started it up and it wouldnt go ito gear. i looked underneath and seen fluid coming from my slave cyclinder. Changed that out in the parking lot. Still wouldnt shift into gear after bleeding a small bottle of fluid through it. i started the car in second gear and limped my car back home. Dropped the tranny and found that 2 finger had broken off the PP. I sent everything back to act they tested it and sent me a new pressure plate. saying everything else was good. Put it all back in. Bled it ran fine driving down the street. then all of a sudden something popped the car wouldnt shift. So i pulled to the side of the road. Popped the hood checked fluids everything checked fine. with the car off clutch feels fine. when i start the motor i push the clutch in it starts screeching. Im thinking the TOB has gone to hell. what do you guys think.

 

[habitatguy187]

Sounds like the TOB to me also, this happened to me recently, but everytime I pushed the clutch in it would start screeching and quickly die if I didn't give it gas. Tore it all apart and the TOB race was melted.