2G License plate bolt pitch?

[Mahreeoh17]

Does anyone know what the license plate bolt pitch is on the 2G DSM rear bumpers?

 

[FIBA M - EC17PSE]

Got a pic of the ones your on about? When i did mine i think most where M6x1.0 which is normal thread pitch for an M6.

Mostly on the 2G its like this

Anything M6 will be 1.0
M8 is 1.25
M10 is 1.25 (fine)
M12 is 1.5 (fine)
I think M14 is also 1.5 but its been a while and i never wrote this M14 down

 

[Mahreeoh17]

Got a pic of the ones your on about? When i did mine i think most where M6x1.0 which is normal thread pitch for an M6.

Mostly on the 2G its like this

Anything M6 will be 1.0
M8 is 1.25
M10 is 1.25 (fine)
M12 is 1.5 (fine)
I think M14 is also 1.5 but its been a while and i never wrote this M14 down

Thanks for the info. The ones I'm referring to are the ones that actually hold the license plate into the bumper through the grommets, pic attached. So they'd be an M6?

 

[dustyboner]

yes M6. Doesn't matter the thread pitch. the grommet is plastic so the bolt (or screw) will cut its own threads in the plastic while you turn it.

 

[AWD-Tony]

They use different bolts from dealership to dealership. You’ll just have to see what fits. It’s plastic so whatever bolt they used is what the thread pitch is.

Looking at the pic and it looks to be m8 or m10 x 1.25 but it’s hard to be sure. Definitely not m6x1

 

[dustyboner]

if your bolt won't tighten just get one a little bigger and you'll be good to go.
i looked on ASA but it didn't show anything for the bolts.
. I thought it had a part number for the grommet (MU480007) but when i searched online i couldn't find a picture that matched up so im not sure. If you look at the grommets in the pictures below, my best guess is this one is what we have

You must be logged in to view this image or video.

metric license plate bolts

You must be logged in to view this image or video.

You must be logged in to view this image or video.

plastic grommets

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

You must be logged in to view this image or video.

 

[Bland-Biscuit]

This is what I ended up using: https://www.amazon.com/Stainless-Steel-License-Screws-Mitsubishi/dp/B073RT7WDY

It has some dimensions on one of the drawings.. Hope it helps.