How much is too much

[Boostedexcel]

is going .30 over on my 6 bolt too much? I have about a .10 in scuff in the cylinder wall, Im concerned that going only .20 over my might be cutting it to close. Is .30 over going to be riskey?

 

[ADrewzki]

0.0030 is fine. 0.0040 is usually considered the "limit" for these motors but I have read of people going 0.0060 and sleeving them (they had hg fitment problems afterwards).

 

[Boostedexcel]

I've been looking at the Ross forged pistons, can I get some feedback from anybody using these with eagle rods?
Thanx

 

[GSX6bolt]

Im getting Eagle Rods, Ross Pistons, Clevite 77 Rod Bearings....

Just understand how strong your motors going to be.. I dont plan on pushing 500 hp in my gsx, but i plan on hitting 350+ and that requires a built bottom.

Go for it, they are very good names ....

I reccommend www.extremepsi.com for your shopping... PLUS

 

[Boostedexcel]

can I get a 4 layer metal misubishi head gasket .30 over?