horsepower???

[90talontsigsx]

ok i've been wanted to know how much power im putting out without having to go to the dyno...i havent been able to go....i just want an estimate

ported(3 1/2 fingers fit on the exhaust side and 4fingers wit some space left fit on the intake side) and polished rebuilt head all new internals

t3/t4 (coldside .60ar) (hotside .48ar)

full 3" turboback exhaust and 3" inlet muffler

MAFT & 3" GM

255hpl high pressure

aeromotive FPR kit

680injector (low inpudent)

aem cam gear (exhaust side) at 2 degrees retard

22lbs of boost

side mount but it is exposed more to the air

hard lower and upper intercooler pipe

 

[Deadly BlaZe]

I personally couldn't estimate how much power your putting down, but just so you know for future references since your a new member, questions like this is considered bench racing and looked down upon on this site and will most likely get locked. And anyway, there are too many variables involved in how much power you have with that set up, the condition of the motor is one of em.

 

[oldman]

I personally couldn't estimate how much power your putting down, but just so you know for future references since your a new member, questions like this is considered bench racing and looked down upon on this site and will most likely get locked. And anyway, there are too many variables involved in how much power you have with that set up, the condition of the motor is one of em.

You're right about bench racing but please report the post instead next time.