Hardwire AEM UEGO

[evileclipse909]

Ok, so the other day I was driving around and screwing around drifting in the snow and what not and drifted right off the road. Well when I did this I bottomed out and riped the connector right off my wideband o2. I have the AEM UEGO and there is nothing left of the o2 side of the connector. I was wondering if anyone could look at theres and tell me what wires connect to eachother through the connector. Im planing on just saldering them back together without the connector.

 

[evileclipse909]

Can anyone help me here. I just wanna know if anyone can lok at their connector and tell me which wires from the o2 connect to the harness for the wideband.

 

[evileclipse909]

I've been searching this site for about 3 days now and cant find anything. I took everything apart. The wires on the o2 are blk, Red, Yellow, White, and grey. However, the wires on the harness are Blk, Green, Yellow, Red, Orange, and Brown. I'm not quite sure why there are 5 wires on the sensor and 6 on the harness.

 

[Auto RS T]

From what I understand, you can't run the wideband without that connector. It has something inside the connector that makes it work and display properly.

 

[romeen]

Jim appears to be right. Scroll down and look at pages 3 and 4.

http://www.aempower.com/images/products/Installation Instructions 30-4100.pdf

 

[b00stedAWD]

It has a built-in resistor, but that should be on the harness side of the plug. You might be able to use male/female quick disconnects to make it work.

 

[1_2befast]

After looking at the one I have sitting here, it seems that your best bet is to just buy a new sensor and male plug if at all possible.