hard bov recirculating pipe

[jdm4g63]

My stock rubber recirculating pipe broke on during my last project and I dare not try to vent again.
I have decided to fabricate a hard pipe to replace it out of 2 90 degree bends of pvc hose, a staight piece of pvc pipe, 4 2" sections of rubber hose to act as couplers and some screw clamps. I hope that explains what I mean.
Has anyone done this/have pics of this? I am also considering adding a partial vent set up in the pipe by putting a crank case ventilator filter on the pvc at some point. Any thoughts or sugestions would be appreciated.

 

[JST2FST]

PM Denji, he has done it and has pics in his profile.

 

[tonygst]

Here we go, i was just on this thread like yesterday and i couldn't find it, i thought it got taken off! But i found it this is great it even goes into detail on placed to find these parts.

http://www.dsmtuners.com/forums/showthread.php?t=163819&highlight=invented

Here yah go enjoy.

Forever

 

[jdm4g63]

Thanks for the help. I can see that I am going to have some work to do because I have a 1g where the bov and recirculation on intake are so far away even with short route piping. I'll post pics when I get done.

Wish me luck.

 

[vtracer20]

yo i dont think the 2" rubber hose will work with the stock bov..i've tried it and the best thing i was able to find was bike tubing, it streches and can handle the psi that ur putting through it