2G Bolts for lower flywheel cover

[Koda]

I am missing the lower flywheel cover and I’m gonna buy the replacement off of stm but I can’t find the hardware and I don’t have it so I have no idea what size it is supposed to be , anybody have an idea ?

 

[Mello]

This take 4 total. Two bolt to the engine by the oil pan MF140722 M6x10. The other two bolt to the bell housing, one is MF140021 M8x12 & other MF241223 M6x12.

 

[Koda]

This take 4 total. Two bolt to the engine by the oil pan MF140722 M6x10. The other two bolt to the bell housing, one is MF140021 M8x12 & other MF241223 M6x12.

Thank you so much @Mello

 

[Koda]

This take 4 total. Two bolt to the engine by the oil pan MF140722 M6x10. The other two bolt to the bell housing, one is MF140021 M8x12 & other MF241223 M6x12.

Another question, do I have to remove the oil pan to install it ?

 

[Mello]

No but you have to remove the transfer case so it's more than just jacking up & bolting it on.

 

[Koda]

No but you have to remove the transfer case so it's more than just jacking up & bolting it on.

Thank you the only reason I asked was cause it have the oil pan off now so I wanted to know whether I could put it on today or if I should wait

 

[Mello]

You can do either or, although they are next to each other they do not interfere with each other. Just make sure you place the access cover up to the tranny before you bolt up the transfer case & I would at minimum install the 2 cover bolt that go into the block by the oil pan too. Don't think it's possible to slip the access cover into place with the transfer case installed and one of the block bolts may get covered up by the transfer. it a five minute job on FWD but not so on AWD.