Are these motor mounts the cause of my problems?

[Dsm_]

I have been having this issue for a while, I replaced the rear motor mount and the front roll stop, When I let of the throttle I hear a clunk and when I take off the tranny feels like its moving too much and binding the shafts. Brand new cv shafts as well. I have posted a video im just not sure how much play there should be.


Motor mounts - YouTube

 

[shibby1036]

Have you even removed the left front axle ? if so check the 2 bolts that bolt the 2 piece axle to the back side of the block. those bolts might have gotten loose, and check the both bolts and nuts to your front struts, where the strut bolts to the wheel hubs.

 

[Dsm_]

Sorry I thought the suspension was obvious that I checked, I have no idea what you mean by the axle being bolted to the block?? My left axle was just replaced and its a one piece axle that slides and snaps into the tranny.. Thats why I posted the video for suggestions on the mounts.

 

[eligst21]

what he is refering to is for awd only. you have a fwd. the mounts seem a bit sloppy, visually check for any cracks and make sure the bolts are in semit tight.