Anyone with Autometer PYROMETER/EGT

[sike]

Question for you guys. I have an autometer pyrometer/egt gauge, and most of the wires fell out of the connector that goes to the gauge. I need to know which wires go where. If someone could take a picture of the connector with the wires going in AND/OR tell me which go where, that would be extremely helpfull. I do not like driving around with this gauge being functional. I do have 2 wires still connected, so I can get an idea of which pin outs you're talking about without a picture. but picture would be helpfull.

 

[99gst_racer]

Which EGT gauge is it? Which series?

 

[sike]

c2, i'd imagine they all have the same connector. I'm not sure though.

 

[RoasT BeeF]

Well you should have 6 wires there.

White and black - bulb

Red and black - 12v power and ground

Yellow and red - probe

What do you need to know?

 

[99gst_racer]

Here's how it goes.....

________________
| 1 | 2 | 3 | 4 | 5 |
-------------------
| 6 | 7 | 8 | 9 | 10 |
--------|_|--------


Pin#1 = red wire going to the probe
Pin#2 = yellow wire going to the probe
Pin#3 = Blank
Pin#4 = white wire - +12 volt dash
Pin#5 = Blank
Pin#6 = red wire - 12volt ignition
Pin#7 = Blank
Pin#8 = Black wire - ground
Pin#9 = Blank
Pin#10 = Blank


I hope this hopes.

PS - This is looking at the plug with the side the wires go into, facing up. Plug side down.