1G anyone use these stm -6an valve cover fittings?

[enriquez2000]

Curious if these are as easy to put in as they say they are. I want to replace the one on the port on the side to use with a catch can setup.

http://www.streettunedmotorsports.com/parts/b/stm_evo_valve_cover_fittings.jpg

 

[chrysler kid]

They dont have raised edges for tension to them, if youre running a catch can breather setup they should be fine. but if you're routing it through the breather or pcv in line I wouldn't run them

 

[enriquez2000]

it would be to replace the breather port to go to a catch can. Does the fitting in the stock valve cover pull out easy or is it still going to require cutting?

 

[b00stedtalon2]

I used them on my Evo and they were easy to install. Can't speak for the DSM but it should be the same.

 

[enriquez2000]

I used them on my Evo and they were easy to install. Can't speak for the DSM but it should be the same.

Does the stock fitting just pull out then?

 

[b00stedtalon2]

Does the stock fitting just pull out then?

Yes, just twist and pull. The STM ones go in with a little force or a rubber mallet.