AEM twinfire + COP wiring HELP!

[NemesisTalon88]

I'm only days from getting my car started with very little things left to do. I already have my coil on plug kit and i just ordered an aem twin fire..but I don't understand the instructions on how to wire part of it to my it to my ignition ignitor? I was following this diagram...

COP in 4 channel and 2 stock igniters possible with EMS?
this is what I am following but I dunno it its the right diagram I don't understand the igniter part.

 

[DSMified92]

ok so do you have the actual aem box hooked up like it has power and the tach is hooked up

 

[NemesisTalon88]

ok so do you have the actual aem box hooked up like it has power and the tach is hooked up

not yet i kinda want to have an idea before i start wiring i just dont understand how to wire it up to my ignition triggers the WHITE and GREEN wires

 

[NemesisTalon88]

doesnt anybody have COP setup with AEM TWIN FIRE??????

 

[kicker91laser]

You just need to look at your coil wiring. You should have three wires that run to the two stock coils, one wire is a common between the two, the other two will be connected to the ign trigger inputs of the twinfire. As far as which goes where, you are on your own, you have a 50/50 chance of it being backwards

 

[NemesisTalon88]

You just need to look at your coil wiring. You should have three wires that run to the two stock coils, one wire is a common between the two, the other two will be connected to the ign trigger inputs of the twinfire. As far as which goes where, you are on your own, you have a 50/50 chance of it being backwards

haha okays thanx lets hope i dont start fire///