46.1lb/min good for a 6152e?

[eder-loco]

I have a pte scm 6152e. Flowign at 46lbs/min is that good for a stock 6 bolt, water/meth/ cams( but no head work)/, evo III manifold, evo III housing, SBR frontmount. and 23psi?

 

[Staytuned]

Seems pretty accurate......can you post a log?

 

[eder-loco]

is in laptop, very hard to xfer into here due to all the damn spywere in it. but i'll try.

 

[99gst_racer]

Doesn't the 6152e use a 60-1 compressore wheel? If so, then it should have a good 10-15 lbs/min left in her. Crank up the boost!

 

[eder-loco]

I have no funds to repair my block if it goes Boom

 

[Staytuned]

I have run 30 psi numerous times on my stock 7 bolt ..... you should be able to get a few more psi on your setup.

 

[Jst4Cyl]

When are you seeing full boost?

 

[SonySlave]

My best friend has been seeing 50-51lb/min out of his 6152E with the Mitsu housing at 28-30psi. So depending on your boost level, that seems accurate.

 

[Staytuned]

When are you seeing full boost?

Me?

@ 4700-4800 rpm

 

[eder-loco]

My best friend has been seeing 50-51lb/min out of his 6152E with the Mitsu housing at 28-30psi. So depending on your boost level, that seems accurate.

22-23psi on 93octane was when i reached 46.1