2G Head and Cams Swap. HELP!

[Captainredeyez]

Ok here is the story. The current head on my car is stock. I did a timing belt change and found that I had no compression, thus I have bent vales right. So I pulled the head and I was correct. I have super tiny indention's on my pistons. Not really a problem right? I bought a 2G head that has been shaved, vales ran, new valve seats, 3G lifters, but came with no cams. I should have no problem just pulling the cams from the original head and putting them on the new one right? I hope someone can help answer this.

Thanks guys,
James