2g/7bolt front case picture/diagram needed

[slipstream808]

OK, so there is an issue in getting that front case on the engine. All the bolts got kicked around and messed up. So at this point I don't know what bolts go where and this is for the oil filter housing, the front case, and the lower timing cover. Where is the best place to find this info out? Anyone have a picture?

The VFAQ, FYI, is a 6 bolt and the bolt lengths don't match up to the 7-bolt ones. Unless I can't measure that is. Then I'm all wrong. Shoulda put em all in bags...

 

[turbosax2]

You must be logged in to view this image or video.

 

[slipstream808]

Dang-nabit... there's one!

Wonder if anyone has any real actual pictures and not diagrams. But thanks so much for that first diagram.

Searches for this return like 500 things and after 4 pages nothing looks right or gives me what I want so it's hard to figure what is good to search for.

 

[turbosax2]

I'm working on pictures for the front case and oil pump. What kind of pics do you want for the timing belt cover?

 

[turbosax2]

1 - Washer assembled, M8x65
2 - Washer assembled, M8x75
3 - Washer assembled, M8x65
4 - Washer assembled, M8x4X

You must be logged in to view this image or video.

 

[turbosax2]

1 - Flange, M8X20
2 - Flange, M8X20
3 - Washer assembled, M8X22
4 - Flange, M8X20
5 - Flange, M8x40
6 - Flange, M8x25
7 - Flange, M8x32

You must be logged in to view this image or video.

 

[turbosax2]

Anything else?

 

[Tatanko]

You, sir, are a godsend! We were worried we'd have to try every bolt in every pile to get the right ones

 

[turbosax2]

No problem, good luck!

 

[slipstream808]

My GOD... you want a cookie for all this? That's amazing!

 

[ziggo0]

Bump because I found this useful, however - 3 hours to late. Thanks Turbosax!

 

[kanusky1990]

Bump cause this is something I was trying to figure out too and this helped tremendously! Maybe a moderator can change the title or make this easier to find for future use. I searched "front case bolts" and this was on the 4th page. Either way, its way old but still helps!

 

[BogusSVO]

You are correct, this thread should not die.

I just linked it to another thread.

http://www.dsmtuners.com/forums/cylinder-head-short-block/471999-bse-front-case-prep.html

 

[Ghost_92TSi]

Useful, I have four sets of bolts because I order a new set from the vendors every build.