Resolved 1G need picture of the knock sensor connector

[3kgt2nv]

I need a picture of the knock sensor connector and where it ties into the wiring harness. And if you know what color its wires are that would help also.

I have spent the last hour searching and I think I have the wiring color down but no one shows a picture of where it ties into the harness at.

I have a 90 so I dont know if its different for 1g/2g

 

[9!'clipseDOHC]

It comes off the firewall behind the intake manifold, before the coil and power transistor wires. It should have 2 wires, in the harness it's a single thick brown wire but the two individual wires are inside it.

You must be logged in to view this image or video.

 

[3kgt2nv]

YeaH I saw that but i need an actual picture of how it comes out of the wiring harness and the location. I think my plug is missing and i need to open the harness to find the wires to put a plug back on to connect the knock sensor.

 

[9!'clipseDOHC]

YeaH I saw that but i need an actual picture of how it comes out of the wiring harness and the location. I think my plug is missing and i need to open the harness to find the wires to put a plug back on to connect the knock sensor.

White and black. White goes to ECU pin #9, black is a ground. In the harness though they are coved by a brown cover.

You must be logged in to view this image or video.

 

[19Eclipse90]

What Nathan provided above should be sufficient for you, but just in case...

You must be logged in to view this image or video.

 

[3kgt2nv]

Thanks thats what I needed. Rep given where I could

 

[ErikTande]

What Nathan provided above should be sufficient for you, but just in case...

You must be logged in to view this image or video.

Thanks for the pic. Just used this as reference!