Rice80
Probationary Member
- 12
- 0
- Nov 27, 2011
-
Kelowna,
BC, Canada
Hey guys, a few questions here. I am installing my new blacktop CAS to swap out my current greentop to see if that will get rid of my P0300.
1) After installing the blacktop CAS and I want to set the base timing to 5 degrees, do I follow this same procedure? 99 ECU with a 6 bolt motor, wasn't sure if anything was different regarding the alligator clips, etc.
Also I only set the timing with the clip attached to spark plug one? I don't have to go through each spark plug wire?
Link:Engine Timing
2) Before I set the timing I have to make sure the BISS is set properly, do I follow the 1G or 2G biss adjustment on the vfaq? Again, not sure if its to do with the 1g motor or 2g ecu?
Thanks all
1) After installing the blacktop CAS and I want to set the base timing to 5 degrees, do I follow this same procedure? 99 ECU with a 6 bolt motor, wasn't sure if anything was different regarding the alligator clips, etc.
Also I only set the timing with the clip attached to spark plug one? I don't have to go through each spark plug wire?
Link:Engine Timing
2) Before I set the timing I have to make sure the BISS is set properly, do I follow the 1G or 2G biss adjustment on the vfaq? Again, not sure if its to do with the 1g motor or 2g ecu?
Thanks all
