Turn Signals Keeps Popping Fuse

[Death_Trap22]

Turn Signal keeps blowing the 10a fuse, i saw corrosion on the terminals and decided to cut the harness off and seperated the wires, to see if the pos & neg were some how touching.Does anyone know if there is a relay or where to start looking?

Still blows fuse and this is the only blown fuse.

(Also radio, power locks, heater, interior lights, cig lighter, brake lights dont work)

 

[DSM_PWR]

Those are all conected to the 100a fuse in the engine bay called "Ignition"

Obviously there's a short somewhere and those are THE most painful things to find IMO...

Make sure you double check the obvious, nothing grouding out, nothing touching the alternator (including oil leaks)

Heres a good article on how to find a short
http://www.dsmtuners.com/forums/art...inding-short-partial-short-battery-drain.html

 

[Death_Trap22]

Thank You for your short and to the point response...

Checked the IGN. fuse and it was on the pos. battery terminal and it was labeled 30a and it looked fine...

I replaced the starter and alternator(p/s leaked on the old one) last week.

I am reading the article provided and i hope it will be resolved.

Thank You