2G TPS cutting out under boost

[b00zt3d spyd3r]

Here's a log, a little long . My TPS seems to be cutting out under boost. It goes to 0.0v as shown in log, then if I let off for a bit it will come back.

Is this indicative of a failing TPS or should i be looking for a short or bad ground or something?

Any help or info is appreciated. attaching full log but pull and TPS cut out starts at about 123 seconds. Seems fine while just normal driving.

 

[chrysler kid]

Usually the connector fits very loosely onto the tps. So if your connector is damaged or missing the metal clip you may have to get creative with a few zipties

 

[b00zt3d spyd3r]

Have the metal clip. Just found a frayed spot on the brown/red tps wire. Going to fix and replace tps just for good measure.

 

[b00zt3d spyd3r]

Hmm

You must be logged in to view this image or video.

 

[b00zt3d spyd3r]

Connector has seen better days as well

You must be logged in to view this image or video.

 

[b00zt3d spyd3r]

New connector and tps didn't seem to fix issue so I dived under the dash and pulled ecu to inspect, all looks good, also doing so found this hack job and did what I could to fix. Took car out and didn't buck one time, boosted hard af a few times to see if it was going to donit amd it didn't so I'm calling it a victory.

You must be logged in to view this image or video.