SSI-4 questions.

[Black'95]

Anyone using the Innovate SSI-4? I'm looking for info on whether or not this thing will log IDC on a DSM. Thanks in advance.

 

[Usatuff]

I log a lot of IDCs, O MGs, WT Fs and FMLs with my DSM...


Yes the SSI-4 logs IDC. The SSI4 has 4 channels. Can successfully and very accurately log RPM (from tach), TPS, airflow hz, and boost (using a 10bar sensor) and also log IDC

 

[Black'95]

Haha! Where did you connect for the RPM signal, I'm thinking either pin 10 (Ignition power transistor A), or pin 58 (Engine ignition signal)?

How did you wire to log duty cycle? I was told to just connect the #1 injector wire to the 'CH+' on the SSI-4, but I read in the manual to try to connect 12V to 'CH+', and the injector signal to 'CH-'..... Thanks man!

 

[Usatuff]

Connect the RPM signal to the CH1+ input screw terminal. Connect the CH1- signal to the ground of the RPM signal source. For example the ground of the ignition system at the ignition box, not where it's ground wire connects to the frame or engine.
I can't remember the pin but I know the RPM signal is on the 12 pin connector, you can use this.

Channek 2 is for duty cycle