spongy clutch pedal!! tried everything help please!!

[Stainbox12]

my problem has been going on for a while and i need some serious help. my clutch pedal is very spongy, like it has no pressure, i checked my lines for leaks and found none. i recently replaced the master and the slave at the same time. i also pulled the tranny out and shimmed the pivot ball with a washer. i took out the whole pedal assambly to check if it was worn and it was fine. i don´t know what else to do, the TOB looks fine and it works, the fork is not bent at all, the pivot ball looks fine. i´ve bled this thing to HELL!! and still nothing. can someone give me some advice, is it probably the pressure plate/clutch/flywheel? i really need help on this one. BTW i´ve searched and searched and had found similar problems but they were fixed with the solutions i posted above. i can´t shit in any gear though.

 

[talon212]

www.vfaq.com remove the spring inside the slave cylinder to minus some of the clutch play..

 

[Stainbox12]

Remove it? are you sure? i don´t understand how that would make a difference.

 

[AWDPetmitsu]

Did you bleed the clutch lines??

 

[BC91AWDTalon]

You might want to check the pressure plate to see if its damaged.

Are you running a stock clutch?

 

[Stainbox12]

I tried to bleed this thing to hell. Would a damaged pressure plate cause issues with pedal pressure? Im running a centerforce clutch with a centerforce pressure plate.

 

[DAmotorsports]

I think you just need to bleed the (clutch)master and slave cylinders

 

[Stainbox12]

I have bled this thing until there´s no more air in the lines. when i close the valve, i can still feel some weakness on the pedal. And no, its not the pedal assambly. im going to sell the car, since no one can figure this out.