Right main bearing clearance?

[PrimerPLus]

Just wanted to be sure I have the correct clearance. Picked everything up from machine shop. Clean and polished crank. Have .25mm acl trimetal bearings.

Green plastigaged all main bearings st once.
Torqued to 18ft lbs plus 1/4 of turn.
It reads on them all at .051
Couple of the plastigage stuck to girdle side bearing which is why you see me measure there.

 

[donniekak]

That is within spec, .0008"-.002", with a limit of .004". It doesn't tell you if the journal is round, or if they cleaned the crank properly.

 

[PrimerPLus]

Thank you.

 

[crimsondragon]

Service manual says 16 Ft-lbs. Just a correction.
Did you torque in the correct sequence as well?