2G Rear license plate bulb

[4g63tmotors]

One of my rear license plate bulb holders are bent inwards so i cannot reach it, is there a way to adjust it without removing the bumper?

 

[tunedbysaturnsl]

I think you can get to it if you get underneath the car from the back. I ran a back up camera in place of a license plate bulb lense without taking the bumper off so it should be possible.

 

[TypeONegative]

Maybe try to get a wire hanger and make it into a u shape and try to wrap the hanger over the light and bracket and pull down

 

[chrysler kid]

If you can't reach it then it is best to remove the rear bumper

It's been a while but I remember upgrading the bulbs and having to flip the passengers side bulb housing so that the new led bulbs would illuminate the whole license plate. Both bulb holders aim the light towards the drivers side.

On a 2g I want to say they are both on the same wire, so if you can't feel it and the bulb is still in it you should be able to feel around inside for the wire to bring out the housing