Resolved knock sensor wire to ecu

[lowboost13]

Quick question I was doing a wire tuck and wanted to shorten all of the wires for the ecu and realized the knock sensor wiring is covered with braided wire like a ground. How should I reconstruct that? Since I cut the braided wire in half.

 

[92AWDHX40]

Just make a new wire I did work's fine.

 

[Phantom DSM]

Its actually shielded wiring in junction with the ground. Check out this thread for pic reference http://www.dsmtuners.com/forums/newbie-forum/420860-knock-sensor-wire-broken-question.html
I have heard of radio shack selling shielded wiring
Rewiring knock sensor http://clintsgarage.blogspot.com/2010/05/how-to-rewire-your-knock-sensor.html

 

[lowboost13]

Just make a new wire I did work's fine.

how did u make the new wire?

 

[92AWDHX40]

I didn't make let me correct that I just ran a new wire to the ecu years ago when I did my non turbo to turbo swap on my non turbo. That was it I used that setup with no problems and no braiding of wires.