Is this good Port job??

[MarsaGSX]

Bought used built head.
This stuff should include..
Supertech Nitrate coated SS valves/STD spec
Kiggly race Behive springs
Race port
Bronze valve guides
Competition multi angle valve job

Let me know what you think about port job please.. I'm not knowledgeable in this way.. To me its just deburing whole surface in the port..

Thanks

 

[BogusSVO]

Looks to be a decent clean up job.

The seats look to be stone ground.

Read through this thread, Viper, Turbo23, and myself talk about porting a bit.

http://www.dsmtuners.com/forums/cylinder-head-short-block/453239-critique-my-head-porting-3.html

 

[MarsaGSX]

Looks to be a decent clean up job.

The seats look to be stone ground.

Read through this thread, Viper, Turbo23, and myself talk about porting a bit.

http://www.dsmtuners.com/forums/cylinder-head-short-block/453239-critique-my-head-porting-3.html

Thanks for link Dale,

BTW what would you change on it.. 10k rpms and 12.5mm cams.. looking for FLAT Torque between 6-10k rpms..

Thanks!