Injector Resistor Bypass

[habitatguy187]

I recently scored some PTE HIGH IMPEDANCE 1200s from a buddy while his car is down. I searched both here and on the link forums and can't find anything concerning removal of the injector resistor box and wiring to the new injectors.

So let's hear it.

 

[steve]

Go to the junkyard, get another resistor pack, cut the wires off at the resistors and solder them all together and plug it in.

 

[habitatguy187]

Hmmm, okie dokie! I'll use the resistor off my parts car. Thanks Steve! Great answers as always. There should be another level above "wiseman" .

 

[slowgsr]

Ditto to what steve said. Unplug the box, on the connector attached to the box, joint all 5 wires! This will allow your resistors to see 12v rather then ~4.5v. Then you can just plug the piece back in, and if you wish to convert back just grab another box and plug er in! Atleast you didn't hack your harness!