steve-o_95_GST
Supporting Member
- 663
- 15
- Feb 29, 2004
-
Ft Lauderdale,
Florida
I finished my 6 bolt swap a few days ago and I have supprisingly high oil pressure. I used a new pump and no balance shafts but when Im at idle the needle sits at about the needles width under halfway and when Im crusing at about 3k its around 75-80% of the way up the gauge. Is this bad?, Im just wondering if my bearings will wash out due to my high oil pressure. I havent had a chance to beat on it yet due to break in peroid but Im thinking when I do the pressure will go up even higher.
-Steve
-Steve