DSM Graveyard Built Head

[420Ant2G]

Hey guys, I guess I don't have enough posts to post under the Cyl. Head Thread . I just recently jumped time on my VR4 and needed my head rebuilt ASAP. I am from Kalamazoo so the Graveyard was the first place I went to. They took my bare head resurfaced it, replaced all the guides, ground my valves and my seats and did an amazing job. My head looked and performed like new. They had it done within the day!!! It was an emergency situation and they knew I was extremely pressed for time. If you guys need any work done by them I would not hesitate to take anything there. There machinist is top notch and knows his stuff, I'm building a budget 6 bolt for my galant since I just recently threw a rod bearing and I will be bringing it down there to have them do work to it. I know some people have said bad things about them but they are my #1 place to go to. I have had nothing but good luck from them. Thanks a lot Jon, Branden, and Chris, you will be getting my business
Thanks
Travis

 

[Raymond1927]

I've done business with them before and there parts are great. I give them that but seeing that I'm from California, they sure do like to take there time. And getting someone on the phone is a hard task to do seeing that no one really awnser the phone around there. I'm not saying that this is not a place to do business I'm sure there great guys. And they do things in the greater good for there business. But I'm going to stay with a local shop now. Like RoadRace or FFTEC.com Just my two cents.

 

[tEi Vp DsM]

i've used graveyard hks spec regrind 272 cams,they worked very well and had no complaints,especially for the money.if i had too,i would use them again....