Camber Kit and upper control arm

[93eclipse21]

So I spent some good time on the forum searching for the answer I'm looking for, but could not find anything that would help. I have a 99 GST which I just bought the Ingalls camber kit for. I was looking at the stock upper control arm where the ball joint is and it doesn't seem to have hole for the Ingalls ball joint to go in. The ingalls ball joint has a bolt on both ends...so does that mean I have to create a hole on the control arm in order to install the ingalls camber ball joint?? Below are some pictures of what I'm talking about. I appreciate your help.

Joey

 

[93eclipse21]

You must be logged in to view this image or video.

You must be logged in to view this image or video.

 

[99ECLIPSEGSXDSM]

There's a snap ring and you have to press the balljoint out. You'll see how it goes together after its out. Make sure the slider plates are 100% perpendicular to the car

 

[93eclipse21]

There's a snap ring and you have to press the balljoint out. You'll see how it goes together after its out. Make sure the slider plates are 100% perpendicular to the car

Oh ok. So I don't need to drill anything or buy another part?? Lol

 

[99ECLIPSEGSXDSM]

Not at all. Just get a ball joint remover from autozone or advance. Pretty simple job