Bore question

[1991_talon]

I bored out my talon .030 over and I am going to replace the head gasket. I need to know if I can still use a stock size gasket or if I need to do anything to compensate for the over sized pistons. I know this question probably sounds dumb but I am new to the bore game. I will use a non MLS gasket because my head is surfaced but not my block recommendations for the gasket would be appreciated, thanks.

 

[Cdc1221]

Stock should do fine. But as far as i know, there are no .030" over pistons offered?

 

[Paul@RTM]

I need to know if I can still use a stock size gasket

The stock gasket is good for up to .040" over bore.

 

[Lou98GSX]

the most you can go is .040 over and you can use the stock mls gasket .

 

[Purple_Demon]

Ross Racing pistons are available in .030 over

 

[BogusSVO]

According to the Fel-pro Master Catalog

HG Part number 9627PT has a bore size of 3.405

STD 4g bore is 3.346 + .030 = 3.376

 

[1991_talon]

According to the Fel-pro Master Catalog

HG Part number 9627PT has a bore size of 3.405

STD 4g bore is 3.346 + .030 = 3.376

its on my head now motor is ready to drop