boost gauge and ebc

[dsmmack]

hey guys, ok this may be a really dumb question but i just want to confirm this before i do the installs...i know can tap in both the boost gauge and an ebc at the same source, the line going from the intake to the fuel pressure selinoid, does it matter if both are tapped in there? meaning if i just run one line through the firewall and have a T fitting there, one to go to the boost gauge and the other to the boost controller, would that make either one read incorrectly? thanks, again maybe a retarded question but just wanted to make sure, thanks guys!

 

[rarson]

I would recommend you tap the boost controller from a pre-TB source. In my experience, tapping the controller from the manifold results in less precise boost control.