bellhousing crack

[crimsondragon]

Found a crack in the lower part of the bellhousing. I think I'm fine but I just want to make sure. It's a crack below where the trans mate to the engine so I don't think there's any load on it other than the flywheel inspection plate. Thoughts? If nothing else I'll just stopdrill it to prevent it from getting bigger.

 

[92AWDHX40]

I would have it welded mine broke and it was welded again, take it to a welding shop or diy.

 

[jayson427]

That's a decent crack, bigger then the one I had. I still took mine out to remove the housing and got it heliarced for piece of mind.

 

[HIGHPSI4]

Yea, you need to get that welded up before you put it back on the engine.