97 GST Startup soon, just have a few wiring questions

[EclipseAnders]

Hello and greetings from Finland!

I am starting my 97 GST soon and I have a few questions. First of all;
I have two connectors that I need to know what goes where. The other one
goes to the radiator fan and the other goes to the AT wiring harness. The
connectors are similar, that´s why I am asking.

This is the first one

You must be logged in to view this image or video.

And the second

You must be logged in to view this image or video.

Then a question about 02 sensors(front). I need to replace mine and I was wondering to go for universal 02sensor. Can these be used on DSM:s?
Is there a wiring diagram somewhere?

Finally, Where does this harness go, or is it from an other car?
I found it along with other stuff from this car and I can´t remember where it is from. It lookes like a negative cable. The harness does have a tag with partcode MB 818 591 on it.

You must be logged in to view this image or video.

Planning to start car tomorrow, I hope you guys can find some time to answer my questions

 

[EclipseAnders]

So I bought the universal 02Sensor. Found the wiring diagram here! I tried to start the car today but the fuel pump did not work. Does someone have any ideas what that could be?

Ideas of the fittings?The other one has colors:
Green
Black
White
Red

The other one is also a 4 wire. I dont remember the colors but one of the wire colors was orange.
One of them goes to the FAN and the other one goes to the AT harness. I just want to know which goes where.

I hope someone can help me

Can someone please help me with the connectors.

 

[spooled_u_1st]

I had a thread about that grey plug. I still never figured it out yet? It's been cold and snow so the gsx just sits in the garage. Anyhow, I am going to get back to work on the car, it's going to be warm soon. I hope.

http://www.dsmtuners.com/forums/newbie-forum/358593-what-plug.html

That grey plug is the Pulse Generator Connector. Check the thread I posted above for more info.

 

[EclipseAnders]

Thank you for your answer spooledu1st! No I still haven´t figured out where those connectors should go. All help would be appreciated!

 

[spooled_u_1st]

Does the connector in the second picture come off of the main wiring right beside the grey Pulse Generator Connector?

What are the wire colors?
orange / white
red / blue

If it is, it's the Solenoid valve connector.

 

[luv2rallye]

Or if the 2nd picture connector wires are green-yellow, brown-red, yellow-red, black (note: they may be faded) it's probably the throttle position sensor (A-63).

 

[91talonawdtsi]

look around the back of the motor i thing there is a connector there it plugs into. It should be underneath the second runner on the intake.