420a Transmission Pivot Ball plastic cap

[James Browning]

Does anyone know where to get this part? I'm reinstalling my transmission and in this thread (http://www.dsmtuners.com/threads/clutch-fork-pivot-ball-replacement.435172/) bulletdsm says that he just replaced the plastic cap on top of the pivot ball because it suffers the majority of the wear. Does anyone know where to get this plastic cap? I was going to message bulletdsm but I saw that he hasn't been on since 2014.

 

[dsmcrzy]

I haven't seen where you can get just the cap... you can buy the whole piece though. Just use a vice grip and a hammer to pull out the old one. Then a soft mallet and socket to put the new one in. Just did mine a few weeks ago.

Where to buy it:

http://www.modernperformance.com/pr..._Neon_SRT4/95-99-neon-drivetrain-transmission

How to remove it:

You must be logged in to view this image or video.

 

[James Browning]

I haven't seen where you can get just the cap... you can buy the whole piece though. Just use a vice grip and a hammer to pull out the old one. Then a soft mallet and socket to put the new one in. Just did mine a few weeks ago.

Where to buy it:

http://www.modernperformance.com/pr..._Neon_SRT4/95-99-neon-drivetrain-transmission

How to remove it:

You must be logged in to view this image or video.

Oh nice. Thanks a ton. Did you use a locking compound on it when you installed it or will the fit be enough to keep it in?

 

[dsmcrzy]

It's an interference fit. Just throw it in as it comes out of the bag.

Plus there's no way it can come out since it's always in compression.

 

[James Browning]

It's an interference fit. Just throw it in as it comes out of the bag.

Plus there's no way it can come out since it's always in compression.

Oh yeah I forgot about it always being under compression, thanks man