Hello all! I was working on getting a standalone ECU put into my car / installing BC coils. Took it for a drive after it had been sitting for about a month when I heard this ticking noise, I know its not the motor because it doesn't tick while its parked (at idle). If I'm rolling down a hill in...

My 1995 transmission is leaking oil from a hole above the transfer case's output shaft, inside the bell housing. Gear oil gathers on the inside, then makes its way to the outside, leaving puddles under the car. Oil also runs along the driveshaft to the rear adding to the puddle. I've attached a...

Car is a 93 Talon, manual (confirmed to have 93+ trans) Ever since I got this car in 2020 2nd and 3rd have kind of "clunked"/"grinded" into gear.Last year I refreshed the trans, replacing all synchros (except 5th/reverse), new keys, springs, 1/2 and 3/4 shift forks, new bearings, cleaned out...

Ive picked up what i believe and was told is a Early 91 3/4 hub, slider, gears, shift fork (2 hole), input and intermediate shafts. Ive got a 93' w5m33 trans already in working condition but wanting to "upgrade" the 3/4 to postpone me buying a dogbox for a little while. From what i understand my...

I have attempted to find this info without really getting a confident answer. However, I can only assume it is due to a supersession, but my part catalog does not show this.In the photos you will see two 5th gear assemblies next to each other. The one of the left came out of a 1993 GSX AWD...

In the photo you will see the intermediate shaft assembly sits slightly higher than the input shaft assembly in the case. I believe this is causing too much clearance between the input shaft bearing race and the case which doesn't crush the solder at all when assembled. I did replace both top...

Can anyone tell me where these 2 shorter bolts go in the mid case of the w5m33? I guess when I tore it apart I didn't pay enough attention to where these 2 went. I've tried looking at obvious places they would fit but they seem too short for everywhere and I can't find a diagram or post about...

Rebuilding / refreshing my 93+ trans with new stuff.I've been referencing the service manual exploded views to see how to put everything back together and check clearances, etc etc.This is the manual I've been using You must be registered to see element.The diagram shows that there is one...

Looking for recommendations on rebuilding/fixing my trans.So my 93 trans has been having issues grinding into 2nd and 3rd and decided to pull it apart to check it out.It was "rebuilt" about 10 years ago by a local shop. Previous owner drove it for maybe 800 miles and then parked it due to...

I replaced my clutch, pp and flywheel. Now in the process of needing to shim the pivot. Upon draining the fluid, I see this. Fluid was clean when I drained it the first time. When I drove it after the initial install, there was a rumbling noise on decel in third gear. There is obviously...

Hey guys!So i'm building my box at the moment and I've just run through and done a set of solder crush tests using soft 3mm solder as instructed by the transmission service manual. This box had seen ~80 thousand miles before I removed it due to the crankwalk bolt stripping the thread out of...

Hi guys,So what does everyone who runs a mechanical clutch type LSD (Eg. Cusco LSD134C), use for their gearbox oil. Im having issues finding something to go in the box that meets the 75W90, GL4, and LSD compatible requirements.TIA!