I have a fp intake recirculated I’m going to swap to the 2g maf I’ve read that I can swap it and put in some 550cc injectors and should be good I don’t have a tuner so it would work. I want to make sure that’s correct so if I need anything else… besides plug and play connector and 2g maf with...

(Long thread warning )So I wanted to post this as more of an informational/discussion thread based on coolant pressure monitoring on a 6 bolt motor. I’m doing this because I couldn’t seem to find any solid “answers” or info on-line other than researching fluid dynamics and running into the...

So after a test pull on the street @ 26-30 Psi to 7000 RPM 43db knock (Haltech elite) on 93 I noticed evidence of coolant on the transfer pipe which looks to be coming from the water/pump o-ring to pipe connection. (See photo). I’m not sure if I should be concerned about this, but I kinda am...

This is the Build Thread for You must be registered to see element.. Reply below.

Hey Everyone, Vehicle is 1990 Eagle Talon Tsi AWD. Pretty sure its Federal as well.So I have seen multiple diagrams of how the 1g DSM vacuum lines should be, I guess I just wanted to confirm if this setup makes any sense. I'm assuming the solenoid all the way to the right is the fuel...

Hi! I am new to the eclipse platform, and recently purchased my first dsm. Its a 4g37 1g Eclipse 5spd.Upon purchasing this car, I have already had to replace the starter twice, with a new one, in one week, first time due to a fire. Is there any reason my car is having issues with the starters...

Hi all, long time no see. Long story short my car build went a little further than I was expecting and now have a goal of 700+ hp . I am going to be running a mechanical fuel pump and looking for advice!I planned on following this diagram of how the lines are ran below. I contacted the person...

Hi, seriously is this the clearance that Precision built their turbos at the oil drain adapter? If it isn’t clocked enough the compressor housing will hit the -10 fitting “the bolt that is”??? This is a PTE oil drain adapter for -10an Is this the way it is with these turbos?Also anyone use...

Just recently converted to speed density, I have the car dialed in pretty good cruising and what not but at WOT it seems to get knock 2/4 pullsFIC 1250cc injectors 255 walbro -6 lines everywhere fuel lab filter aeromotive fpr set to 40 psi fp red turbo greddy bov 2.5 inch piping mishimoto...

Please forgive me up front for this is my 1st turbo/1G DSM build. Looking for an intercooler that won't delete my factory fog lights. Bought the CX racing kit but the intercooler was huge and deleted them with a lot of front end modifications. I see I have to relocate my coolant tank and removed...

I have the engine codes 11,13, and 15 for my 94 eclipse. Any help for a noobie?

So i got a 1990 mitsubishi eclipse 1g dsm na 2.0l non turbo and i need a coil pack and transistor but am struggling finding any so if you guys got any links to those factory parts or kno of any parts that i could use instead of finding the factory parts please feel free to let me kno itll save...