My brake lights won't work and so far I've been able to find power from the battery to the brake light switch, when the other power output prong on the brake light switch plug is powered my brake lights turn on. All of my grounds at the rear brake light plugs are good. And I've tried two new...

Hi all, I am getting a weird noise in front of my steering wheel when I brake. When I fully press the brake, I don't hear it, but when you lightly press it and slowly slow down, the noise gets louder and louder. I jacked up the car and am able to reproduce the noise by just rotating the wheel...

Several years ago I completely rebuilt my '92 AWD Talon's rear end, taking everything apart to clean it up, remove all the rust, treat and paint all the parts and replace some bushings and other parts before putting it all back together again.In the process, though, I destroyed both ABS wheel...

Does anyone know what rims will fit 1g with CTS-V brake upgrade??

Well I ran into my first big issue with swapping from a 420a to 4g63. I swapped all the harnesses except the one one under the dash because i thought they were somewhat the same.everything plugged into everything the same. I don't know if this was a previous issue in the doner car or what. When...

Does anybody have any experience with these powerstop brakes I know there probably not as good as Brembo but are they worth upgrading from stock?You must be registered to see element.

My 2g has been sitting for a while due to a busted brake line under the car. After working on the engine and cleaning the car up over time it’s time to get the brakes fixed. From my observation I’m looking at replacing all of the hard brake lines under the car. So all new brake lines at that...

Hi, I'm fairly new here so I hope this isn't inappropriate or too long, but I'm about to order a bunch of parts for my '92 Talon TSi AWD manual (build date May 1992), with around 79k miles on it (yes you read that right), and wanted to make sure they're right for the job. If anyone cares to...

Selling the Outlander front brake calipers w/ brackets and the Early ‘95 rear brake calipers w/ brackets as a set. Includes all hardware and some used pads.I bought these brand new at Autozone about 2.5 years ago. These are THE biggest brakes that can fit under stock ‘swirly’ wheels. This is...

Anyone ever buy STM brake lines? Is this supposed to replace all brake lines or just the ones going to the caliper? It seems like its all the brake lines that run from the caliper to the brake proportioning valve. But obviously not the lines that will run all the way to the rear of the car. If...

I am in the process of rebuilding my newly purchased '97 GSX. I'm finally getting near the end of the build and I'm starting to piece everything back together. The guy I bought the car from had already swapped all of the stock brakes with Brembos from an Evo, but I figured since they were...

So I have been trying to replace the OE brake assembly on the back of my '96 gsx. I have everything together now and have yet to flush/bleed everything when I notice the original brake line (the rubber soft ones) are not mating flush with the new calipers... I ordered the powerstop rear brake...

2G Baer brake kit, still in great shape and comes with everything needed to bolt up. These have less than 10,000k on them as my low mileage 95 TSi has never been on the track, sadly... Includes: 13” Cobra R vented cross drilled & slotted rotors Dual piston calipers + pads that still look about...

Does anyone know what is required to convert these ugly drums to discs on the rear? Is it possible to maintain emergency brake functionality? Where would be the cheapest place to buy a kit? And amount of time required to install? I was looking for a little more braking performance.

Hi!I'm currently turboing an N/A eclipse, and well, the factory brakes look very small now to do the job. I read about some budget builds with 3000gt or evo brakes, but those cars are not very common to find in Europe. I also found out that the Mitsubishi Outlander rotors are compatible, does...

Working with my 91 AWD with 1gb front calipers, needed the quick bleed fittings since I have no friends. Thought this will be helpful to others.Rear: Dorman 12709 M10x1.0 35mm Fronts (2 piston): Dorman 12708 M7x1.0 32mmAlex

Up for sale I have a couple of items that I need gone. Prices are negotiable and do not include shipping and PayPal (unless stated). Some items are big and heavy so consider that when I get you a quote for shipping Send me a private message through here. I check this regularly.1) Rear evo...

I have a problem with my 98 GSX. I’ve heard a grinding noise from my front passenger wheel. I tried wiggling everything but it’s all tight and good. The grinding would go away after about 20 mph. Now it doesn’t go away and I slow down a lot faster. I’m thinking my brakes on that wheel are...