Okay so I know this is a covered topic but here are the parameters I am dealing with:Tachometer worked ~2 years ago when I first got the car Tore out full interior and replaced Installed OHM Racing Engine and Fusebox harnesses Using ECMLink (So still stock ECU) Stock ignition coils Car now...

You must be registered to see element.PLEASE SEE VIDEO, THANK YOU!? Is this the sound of a failed fuel pump?Fuel pump is a Walbro 255 HD in a 98 GSX.I've been tracking a no start issue. It may be very obvious. Just wanted to see if this sounds familiar to anyone. This is a start...

So I am currently in the midst of having the engine rebuilt on my 95 gsx.Timing belt got stuck while going 30mph and everything just went loose. Took the car over to my brother-in-law to assess the damage and saw that 6 of the intake valves were bent.Other than that, everything looks good...

This is the Build Thread for You must be registered to see element.. Reply below.

BLUF: Can I run bolts instead of studs to connect the turbo to the exhaust manifold? Additional question about turbo-to-downpipe hardware followsSo this "custom" 2G keeps coming with surprises. The studs that connect the turbo to the exhaust manifold are wonky and APPROXIMATELY a 3/8" diameter...

I have a 97 GST, I lost the key. It has a different ignition in it than the original one because the case have already been lost once. (Not by me)Because of that I cannot get a key made, I've had multiple mobile locksmiths come out and none of them can pick it either. I went ahead and took...

I currently have a Mishimoto front mount intercooler but when I got the car which was 2 weeks ago it came with the ac deleted so I’m trying to get a condenser and compressor installed but my brother said there’s not enough room for it and so I’ve been trying to find a top mount intercooler but...

Hello I’m still fairly new. Have a 98 Eclipse GST. I’m pulling motor and trans soon because I am having my other block sent out and made into a 2.3 stroker with a hx40 setup.Anywho! My stock engine bay harness is beat like Chris Brown did it. Completely hacked. So I purchased an amazing...

I used ECM link v3 to drain old gas in my tank , but after deactivating “fuel pump always on” it also deleted my “fuel priming time” secondsWould anybody know what the stock priming time for the fuel pump is? I set it to 3 seconds but I would like for it to be the intended time from factory...

does anyone know what the fitting on the ends of this fuel line are? i would like to try and have one made before i order this one.You must be registered to see element.

So I replaced both sensors for engine coolant temp. I know they are picky and specific to which sensor has to be installed, make or model or trim ect can throw it all out of wack. Need specific sensor for mine which is a 98 GST. ANYWHO! I 300% made sure I have the correct sensor but my engine...

so im doing my timing and the pulleys one sticks out more than the other. my question does the idler need a spacer? because the tensioner one sticks out a bit furtther. 7bolt 2g dsm

I've been having issues with my tranny going out at 2000 rpms it just slips and I have to be on O/D to be able to drive it normally. So I came across a GST for sale that is also FWD like my Talon and I was just wondering if I could just interchange the parts without having to do too much to my...

title is exactly what it says. sensors and wires all check fine has to possibly be a relay? what else all ties into this. every other sensor is fine. its gotta be a relay or a fuse and changed all the fuses.

well this was a diff thread but now. question is i went to set idle ground in ecm link went to adjust biss. i ended up blowing a fuse? fuel pump wont prime anymore. floor lights wont turn on anymore. dash lights up gauges do. radio does. no crank nothing when key is turned forward. i got 2...

My question to my fellow DSM'ers that didn't get their hands on the holy R&D exhaust is which is better in your opinions: HKS Hi-Power catback or the STM catback exhaust system?

Hello, so some background before we get started. I have 1997 mitsubishi eclipse 4g63 nt, euro. Recently swapped in a 1999 gst engine and 1999 gst black box ecu.I decieded to modify the old nt harness to accomodate turbo applications. So far i have added the MAP sensor, injector resistor, boost...

Hi so i just finished rebuilding my motor dropped it in hooked everything up turn the key everything powers on. gauges light up wont change color for some reason on my glowshift stuck red. go to crank i hear fuel pump kick on no crank no start. weirdly enough headlights i turn on then click off...

Hey guys There is a pretty good bit of separation between the right fender panel and right door going outwards on my 2g. Only on the right side. Got any ideas on how to fix this or what the problem may be? ThanksYou must be registered to see element.

Hello guys I have a 2g gst 1998 and Megan coilovers where just installed about 2 weeks ago it did get lowerd I have about a 2 finger gap all around but the rear is very bouncy if I hit anything it kind of bounces like 3 times on the rear very uncomfortable ride I did adjust the damper for the...

Hey guys,I removed the HVAC controls in my car but is like to retain the front defroster. I can manually set the ducts to blow on the front window but in not sure how to wire the fan to a toggle switch. I'd like to do it properly. Any advice would be appreciated.Thanks!

I keep getting the e8 code on the gauge. I replaced the wideband and even bought the heatsink. I'm thinking my egt is too high and I keep toasting these sensors. I'm new to tuning and I think I might be getting too rich. Any things I can check to verify this weeks help greatly.

A 2g spyder light bar for saleNot in a rush to sell taking offers right now.

Ended up not needing this, going a different route. 150 shipped obo.NEW. Never used, Right Angle 1.8m Extension Cable.435 2three85627 text

Hey guys, I just got an mtx-l plus. Everything that I've read mentions to use the brown wire when installing but this thing doesn't have a brown wire. Only red, yellow, white, and black. Innovatives documentation says the yellow wire is analog out. I've got a 2g with Ecmlink so I was going to do...

Hey guys, there are some really nice shifter assemblies our there for other cars and I'd like to use one from an Acura Rsx. The problem is the cables are shorter for the rsx, if I can get my hands on a set of stock RSX cables would that be ok? The pictures all look like they will fit onto the...

im parting out a 91 talon awd has 78k OG miles the block is at the machine shop just need to pick it up but it will need to Assembled I have trans t case turbo setup downpipe and other stuff just pm me and we can make a deal BUYER PAYS SHIPPING AND PAYPAL FEES. Everything is available don’t...

Complete swap from a manual 95 Talon TSI AWD with LSD rear diff. Every single part you need including hardware. (bagged and labeled)^^ Shipping would be outrageous. ^^There's some surface rust on the subframes and knuckles but everything is 100% solid.I'm posting this to hear offers. Which...