Where to wire aem boost gauge 30-4404 to ecu?

[NVR2LATE]

Tried to search this.

http://www.dsmtuners.com/forums/articles-tuning-ecu/437228-logging-your-35-psi-aem-boost-gauge.html

I just wanted to confirm that the "white" wire or 0-5V wire would go into pin 73?

I installed a Grimmspeed manual boost controller with this gauge so I want the gauge to feed the ecu for data in ECMLink.

Thanks.

 

[92AWDHX40]

ECMTuning, Inc.

have you looked at the site for the inputs, installnewsensor [ECMTuning - wiki]

 

[NVR2LATE]

Well...I've tried. It, of course, gives a diagram of the inputs, but I haven't found one that says, "Put it in here" (that's what she said).

I will admit that I am new to both forums and may have not entered the correct search parameter if you have a suggestion. It seems most the wiring is directed toward wideband setup.

 

[92AWDHX40]

http://www.dsmtuners.com/forums/newbie-forum/420898-aem-tru-boost-dsmlink.html

this may help i dont see anything on that 2g input,



start [ECMTuning - wiki]


Im assuming it would be here on this page for which inputs to use.

 

[NVR2LATE]

Thanks. I'll keep researching. Guess it's possible that hooking it in is futile and unnecessary if there is no easily found answer for it.

 

[WES_393]

The link you posted for the AEM install explains one correct method for hooking up the input, but uses Evo Scan to reprogram the input. So it's fairly useless to a DSMLink user. However, the second link in post #2 is exactly what your looking for. Like it says in that link, you just need an open input to connect the 0-5v output wire from the gauge. After that, you change the pin assignment from the stock input to the device your logging.

 

[NVR2LATE]

Thanks. Looks like pin 73 will be the best slot to use.