where does the oil gauge plug hook to? Pic inside

[7"exhaust_tip]

ya, what the thread name says. WTF.

Oh, and the red wire is for an unhooked ricer lightshow a/f gauge.

Where is it supposed to connect to?




http://i53.photobucket.com/albums/g45/7inchexhaust/100_4400ssss.jpg

http://www.dsmtuners.com/forums/showthread.php?t=260955

 

[Eastwood95]

the red wire goes to pin 76

http://vfaq.com/mods/ecu-harness-2G.html

 

[talontd92tsi]

The oil gauge should hook up right on your oil pressure sending unit, the brass looking thing on the other side of the housing.

 

[7"exhaust_tip]

yeah but on that brass thing, there is nothing. Like no plug.

 

[nc90awd]

it has a little nub in the middle of the round thing. The plug slides over the nub.

 

[7"exhaust_tip]

it has a little nub in the middle of the round thing. The plug slides over the nub.

wtf. theres no way that plug will reach over there.

 

[nc90awd]

the wires must be routed wrong or somthing. If you look on the plug and look at the nub you will see how they go together.

 

[luv2rallye]

Your missing another wire that fits into that connector and goes to the sender with that special plug that slides over the sender's nub: http://www.dsmtuners.com/forums/showthread.php?t=228171#post50377891
And a fix: http://www.dsmtuners.com/forums/showthread.php?t=125944#post1018705

 

[silvercoupe97]

That's a very bad angle.
Judging by how short that wire is, I think it's safe to say that it's for the dummy light. I don't think you have a dummy light sensor there though. It might be tapped elsewhere or you just don't have one because I just don't see it up front like in Luv2Rallye's first link.

That longer wire goes to the pressure sender. BTW, I've used a female spade connector on the pressure sender wire. I had to squeeze it a bit (blue ones, 18 awg perhaps, I forgot) because it was a tad loose. Slid it on and has been there for about a year now.

 

[Defiant]

Keep your pics within specs:
http://www.dsmtuners.com/forums/showthread.php?t=260955

You're missing the pigtail that goes to the sender:

You must be logged in to view this image or video.

http://www.dsmtuners.com/forums/showthread.php?t=257133&highlight=oil+sender

 

[Eastwood95]

defiant is the man

 

[7"exhaust_tip]

so the piece im missing that goes to the oil gauge sender, is there a part # for that?

 

[silvercoupe97]

so the piece im missing that goes to the oil gauge sender, is there a part # for that?

Do you even have the oil light sensor on the housing? Your pic doesn't show it...like I said, very bad angle.

BTW, to make sure you're on the same page as the rest of us. The yellow thing that sticks out of the housing is the OIL PRESSURE SENDER and the little stubby thing by the oil line is the dummy light sensor as depicted in the pic that Deviant posted.

Now, if you don't have the dummy light sensor, there's no need to worry about a pigtail because that should come with the dummy light sensor (oem) and not the plug. The plug allows it to come off with that little tab (look closely at the pic). If you're worried about a pigtail for the oil pressure sender....you don't need a pigtail, you can just splice on a female spade connector, squeeze the curved parts a bit and slide it onto the OP sender's tip.