Resolved Walbro 450 wiring

[Type1DSMr]

You must be logged in to view this image or video.

I'm trying to install a walbro 450 e85 pump and need to know which wires I connect the walbro harness to. Which wire is for the positive and negative? Here's a picture of the stock plug in to connect to.

 

[Archer Fabrications]

http://www.dsmtuners.com/threads/walbro-450-install.437144/page-2

 

[Type1DSMr]

I read that earlier, did you just pull the wires out? I'll try to reuse the pins because I don't have a computer shop close.

 

[donniekak]

I wouldn't run a walbro450 on the stock wiring. The current draw can melt the stock wiring.

 

[Type1DSMr]

I wouldn't run a walbro450 on the stock wiring. The current draw can melt the stock wiring.

OK should I just do what urbansmoker did and pull the stock wires and hook up wires that way?

 

[donniekak]

You'll want to use something like this.
http://www.streettunedmotorsports.com/parts/stm_fuel_pump_rewire_kit.htm

Also, if you don't have an adjustable fuel pressure regulator, you'll need to get one. A Walbro 450 will seriously over run the stock regulator, raising low load fuel pressure to over 50 psi easily. Being a 2g you will also need to modify the fuel tank siphon hose.

 

[Type1DSMr]

You'll want to use something like this.
http://www.streettunedmotorsports.com/parts/stm_fuel_pump_rewire_kit.htm

Also, if you don't have an adjustable fuel pressure regulator, you'll need to get one. A Walbro 450 will seriously over run the stock regulator, raising low load fuel pressure to over 50 psi easily. Being a 2g you will also need to modify the fuel tank siphon hose.

Already have a rewire done, fuelab reg and fuelab filter, and even did the siphon hose mod drill it 1/8.

 

[Type1DSMr]

http://www.dsmtuners.com/threads/walbro-450-install.437144/page-2

How did you remove the wires from the plug?

 

[Archer Fabrications]

You can order actual pins from jnz or ohm racing. I tried to re use the old pins but it didn't work cause i messed them up. Give it a shot, at least the pic shows you which is positive and negative

 

[Type1DSMr]

You can order actual pins from jnz or ohm racing. I tried to re use the old pins but it didn't work cause i messed them up. Give it a shot, at least the pic shows you which is positive and negative

Well I reused the old pins and hopefully it works, if not I'll order new ones. Thanks a lot urbansmoker. Don't know why I over thought it just because they include connectors, however, it's much better to just do what you did.

You must be logged in to view this image or video.