stripped oil feed on head

[teampruven01]

guessin i can just tap this and go with a little bigger banjo bolt? i'm not takin it off to get fixed or relocating... wtf.. one this after another.

 

[1gslotsi]

once you have most the metal out with out the fitting could you not just start the car to blow the metal shavings out you figure there would be enough oil pressure to get any loose shavings that the grease did not get and of course dont let the engine run long i was just running through the scenarios, good luck hope you are able to fix this without removing head but sometimes it is better safe than sorry