SAFC II initial setting

[WuYing]

Hi all! I have a 95 talon awd tsi and here's the list on my current power mods.......Big16g, walbro FP, RC550cc injectors, dejon uicp, hks bov, stock boost, 3 inch piping from turbo back and injen intake.......... I just want to know what kinda setting would be safe to drive around b4 i go to dyno tune the vehicle. The car is running rich now but smile good z......Please advice...... sure don't wanna damage the engine.

 

[WuYing]

again....I have a SAFC II

what's a good general settinig b4 I take it to dyno?

 

[Thomas91169]

i run a conservative tune. evo16g, 550's, 190, fmic.

low side looks like this
-6, -8, then -10 across the board

high side is really rich, but since my palm is at a buddy's, i havent been able to tune.

i believe its -15 across the board, going to -13 at around 7k.


my buddy had a evo16g and was doing around -25 on the high side in some spots. but you gradually work your way to those settings. always gotta be logging, studying, tuning(in 1 point increments), log again, study, confer with other uber tuners, tune, log, tune, log, study, etc.

i assume you have some sort of palm logger setup? if not i wouldnt go past -15 without being able to see what the ecu is doing with timing and how the o2 volts are. btw i hope you have your HI/Low set up right, low side is 35%, high is 80%.

also i believe ProStreetOnline has some "basic" SAFC2 references.

btw nevermind the palm references if youre going to a dyno.

 

[AWDGreenMachine]

Maybe check RRE, I think they have some basic settings on their site too.