ECMlink Prosport wideband signal to ecu

[Buddy2]

Hi!

I have been trying to wire prosport wideband in to ecmlink v3 today as narrowband sim. I soldered 0-5v in to ecu pin 76 and analog output ground in to sensor ground pin. In ecmlink ecu input page i did set front o2 as narrowband sim and selected front o2 as WB and saved all the changes. How ever in values i cannot find this new setting so i cant log it.

What am i doing wrong?

Thanks!

 

[Buddy2]

Problem solved! Either i was blind or restarting program solved problem. (morelikely blind) Any suggestions how to run prosport as my v3 has no prosport option. Should i run it just as linear WB and start calibrating it from there?