BoostBuddyGSX
10+ Year Contributor
- 75
- 2
- Oct 7, 2009
-
Central,
New Jersey
Hey guys.. So my 96 AWD M/T transmission and my ACT2600 pressure plate/street disc combo both have occasional temper tantrums. To start off, everything is fine about the clutch. I had the clutch installed and the trans rebuilt "professionally" by JNZ Tuning
And I set the engagement point just where it's normally set at (pretty low) and it holds power great. The problem is, <b>ON OCCASION</b>, the engagement point is almost at the top of the pedal when it's at full operating temperature (e.g. when I've been cruising around a lot). Odd? 
Now the trans...
1st gear is fine. No problems.
2nd gear grinds
every single time.
Here's the tempermental part..
3rd gear has a mind of it's own, and engages when it wants to. I have tried different speeds, different revs, different loads. Monday it was doing better. Tuesday I did a 2-3 pull and popped it right into 3rd with no problems, no grinds, no hesitation. Wednesday, no problems. Now today it started not engaging 3rd again. If I put it in 3rd, the gear selector goes into the "slot" it's supposed to, but it just revs and you can hear a sort of a crunchy/crackling noise. It's WEIRD
Ok, 4th is fine.
5th got STUCK IN GEAR 3 times on the highway yesterday! (Wednesday) I managed to get it out of gear all three times with a good tug, but today (Thursday) I had no problems with 5th... GAHHHHHHH
Advice! Please!!
And I set the engagement point just where it's normally set at (pretty low) and it holds power great. The problem is, <b>ON OCCASION</b>, the engagement point is almost at the top of the pedal when it's at full operating temperature (e.g. when I've been cruising around a lot). Odd? 
Now the trans...
1st gear is fine. No problems.
2nd gear grinds
every single time.Here's the tempermental part..
3rd gear has a mind of it's own, and engages when it wants to. I have tried different speeds, different revs, different loads. Monday it was doing better. Tuesday I did a 2-3 pull and popped it right into 3rd with no problems, no grinds, no hesitation. Wednesday, no problems. Now today it started not engaging 3rd again. If I put it in 3rd, the gear selector goes into the "slot" it's supposed to, but it just revs and you can hear a sort of a crunchy/crackling noise. It's WEIRD
Ok, 4th is fine.
5th got STUCK IN GEAR 3 times on the highway yesterday! (Wednesday) I managed to get it out of gear all three times with a good tug, but today (Thursday) I had no problems with 5th... GAHHHHHHH

Advice! Please!!

I figured.. I just spent a lot of cash money to "rebuild" it. Problem is, JNZ is/was reluctant to honor any type of warranty whatsoever....
So I'm SOL