1G Mtx-l WB, Dsm link, o2 sensor+housing

[Freddyk79]

'91 GST, 99% stock.
I'm going to install my innovate wideband (first time), and I do have dsmlink v3. I have searched here but there are lots of threads and tons of info and lots of different ways to install the WB. here r my ?'s.

I have read I can swap the stock narrowband o2 for my wideband o2 and just run narrow Sim via link. Correct?

Also there lots of guys talking about the ecu, wiring direct, pin this and that. Since I have link I don't need to mess with that correct?

So pretty much wire up power, ground and o2, calibrate, narrow Sim and good to go? Anything I've missed?

 

[GST with PSI]

Start here:
http://www.dsmtuners.com/threads/lc2-wideband-install-questions.487609/#post-153479100

More info here:
http://www.dsmtuners.com/threads/innovate-mtx-l-wideband-question.487051/#post-153489007

Then, go fill out your profile: http://www.dsmtuners.com/threads/we...o-create-a-dsm-profile.499707/#post-153564173

 

[lasershark]

http://www.ecmtuning.com/wiki/lc1install pins to use for narrowband
helpful info http://www.dsmlink.com/images/forums/1GECUPinout.pdf
You are going to want to pick a ecu input pin to wire the wideband to so the ecu gets the sees the voltage if you want to do the narrow band simulation.

It's pretty simple GST beat me to it but here is some more helpful links...

 

[Freddyk79]

Start here:
http://www.dsmtuners.com/threads/lc2-wideband-install-questions.487609/#post-153479100

More info here:
http://www.dsmtuners.com/threads/innovate-mtx-l-wideband-question.487051/#post-153489007

Then, go fill out your profile: http://www.dsmtuners.com/threads/we...o-create-a-dsm-profile.499707/#post-153564173

Thank you sir. I finished my profile finally too.