- Thread starter
- #26
ishnish
10+ Year Contributor
- 940
- 156
- Jun 26, 2011
-
Modesto,
California
Okay well I installed the switch today just now got done. When I turn on my gauge, it still reads 7.4, which I'm sure is normal for now being that I didn't install my sensor yet. But also, my led light stays blinking. When I hold it down, it turns off until I let go, at which point it starts to blink again. Is this normal?
I figured since I didn't install my new wideband sensor yet, that maybe it is normal.
I figured since I didn't install my new wideband sensor yet, that maybe it is normal.
