Just finished my AWD swap but my damn fuel gauge isnt workin!!!

[johnmarines]

Okay guys I just finshed my AWD swap on my spyder WOO WOO. I really havnt taken it for a drive yet because I wanted to get my fuel gauge working. I have read alot on this and for some reason it wont work. Can someone please verify that the wiring diagram I have is the correct one. I do have my fuel pump rewired so Im not sure if thats the cause. Here is the diagram I followed. BTW..Yes i do have fuel.. I put 5 gallons in.. the car does start and run.

You must be logged in to view this image or video.

Thanks guys....

Anyone?

anyone???

 

[casperfast]

there is a small possibility that the sender lever/ float is stuck or jammed. i've seen them installed a little crooked and they interfered with the side of the tank and wouldn't move.

 

[johnmarines]

I thought of that so I went to the station and filled up.. my gauge move to right below half full. So I'm assuming my gauge is only working half ohm

 

[johnmarines]

Just wanted to update this thread and say the issue is now fixed. The schematic in the original post is correct . I was installing the new jay racing fuel pump and realized that one of my connectors wasn't pushed in all the way. I pushed it in and the gauge started working. Woo woo

 

[92AWDHX40]

Good to hear.

 

[nuclearr]

Thats good I have not gotten mine to work yet. Well at least work all the time/ or correctly. I think its the senders themselves.

 

[johnmarines]

Thats good I have not gotten mine to work yet. Well at least work all the time/ or correctly. I think its the senders themselves.

Have you verified the wiring is correct ? If its working sometimes it sounds like a connection issue.