Heading to the Dyno

[1998gstmaniac]

wazup, im heading to the dyno this thursday to get a few runs in. i was just wondering what numbers i could expect from my setup. i was hoping for something close to 300 whp but im not really sure. i just dont wanna get my hopes up. thanks

heres my setup;
14b ported and clipped, 3" intake , 650 injectors, 255 fuel pump, MBC, APEXi safc2, 3" turbo back exhaust no cat, short shifter, FMIC, 2.5" IC pipping, HKS SSQV, TurboXS boost comtroller, ported exhaust manifold, Poerted O2 housing,

oh yah...im gonne be runnig about 17 psi on the 14b.

 

[CanadianTSi]

Anywhere from 220 to 280...all depends on the Dyno...

 

[Grn95GST]

why only 17psi? Seems that you have the mods to max out the 14b, so why dont you? Do you have an AFPR?

 

[scottsee]

is a FMIC really nessasary on a setup like that?

 

[CanadianTSi]

is a FMIC really nessasary on a setup like that?

If you want to take the 14b to it's full potential, Yes.

 

[1998gstmaniac]

yes i have a fpr, what would be the max boost i can run, like 20-21 or something.....and the reason for the fmic is because im planning on upgrading the turbo in the near future...

 

[1998gstmaniac]

Just got back from the dyno and im probobly the happiest man alive right now. The car made 307.2whp and 298tq. i ran the car at 20 psi and it took them 2 hours to tune it. I dont know how this happened but ill post the graphs up this weekend. later.

 

[gstspyda97]

you are my new hero
those numbers

im running a similar setup and hoping for the same

 

[94awdcoupe]

put some race gas in it and turn it up to 25 psi. it will fall off in the upper RPM, but if your going to dyno it, might as well make it worth while.

 

[CanadianTSi]

Just got back from the dyno and im probobly the happiest man alive right now. The car made 307.2whp and 298tq. i ran the car at 20 psi and it took them 2 hours to tune it. I dont know how this happened but ill post the graphs up this weekend. later.

Good Numbers, I wish my Local Dyno was an "Ego" Dyno

 

[captd108]

what kinda dyno was this done on?