Greddy 18g:exhaust Housing?

[diamondstargsx]

i got a greddy 18g 49179 3inch inlet compressor housing and center section.i did not get the exhaust housing with it and heres some questions i have:

since its an 18g i cant use my 6cm exhaust housing right?

can i use a 16g 6cm exhaust wheel so it will fit in the 6cm housing?

if i have to use a 7cm who sells just a 7cm exhaust housing?

if anyone has any other ideas let me know!!!!

You must be logged in to view this image or video.

 

[green92gsx]

I'm pretty sure your 18g comes with a tdo5h turbine wheel. So it'll fit into either a mitu 6cm or 7cm turbine housing.
Slap the 7cm housing on there and you will have a nice little setup.

 

[diamondstargsx]

i found out thats its from a honda kit a greddy 18g td05 so it will fit the 6cm housing right?

 

[sweet97]

It has an exhaust wheel on it right? See if bullseye housing wil fit. It will set you back $229. but is an awesomturbine. ark

 

[green92gsx]

i found out thats its from a honda kit a greddy 18g td05 so it will fit the 6cm housing right?

Yes, it will fit into a 6cm turbine housing. I would go with a ported 7cm housing for some top end though.

 

[CanadianTSi]

Yes, you both might have to do a bit of tweaking but you will be able to make aftermarket UICP's work with a Supra SMIC.

 

[doug]

Make sure that on whatever turbine housing you choose, the wastegate actuator arm will line up with the flapper hinge post (or whatever it's called).